Xiamen Seals Technology Co.,Ltd
Contact Us
Xiamen Seals Technology Co.,Ltd
Address: Unit233, No.273, Lingxia North RD, Huli High technology District, Xiamen, China
Tel: +86-592-5775761
Fax: +86-592-5775761
E-mail: info@sealsmanufacturer.com
Home > Knowledge > Content
Standard Test Methods for Rubber O-Rings
Oct 19, 2018

Significance and Use

4.1 These test methods provide acceptable procedures for quality control purposes and for the determination of engineering characteristics.

1. Scope

1.1 These test methods describe the procedures for determining the physical properties of O-rings and changes in these properties due to aging.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) 

ASTM Standards

D297 Test Methods for Rubber ProductsChemical Analysis

D395 Test Methods for Rubber Property--Compression Set

D412 Test Methods for Vulcanized Rubber and Thermoplastic ElastomersTension

D471 Test Method for Rubber Property--Effect of Liquids

D573 Test Method for Rubber--Deterioration in an Air Oven

D865 Test Method for Rubber--Deterioration by Heating in Air (Test Tube Enclosure)

D1329 Test Method for Evaluating Rubber Property--Retraction at Lower Temperatures (TR Test)

D1415 Test Method for Rubber Property--International Hardness

D2240 Test Method for Rubber Property--Durometer Hardness

D3767 Practice for Rubber--Measurement of Dimensions

D4483 Practice for Evaluating Precision for Test Method Standards in the Rubber and Carbon Black Manufacturing Industries

E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

Aerospace Standard

AS568A Oring Sizes Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.


Accelerated Aging Test - Aging Test - Compression Set Test - Compression Test - Corrosion Test - Density And Relative Density - Hardness Test - Mold Shrinkage - O-Rings - Physical Properties - Relative Density - Rubber Rings - Shrinkage - Tensile Test

ICS Code

ICS Number Code 21.140 (Seals, glands)


UNSPSC Code 13100000(Rubber and elastomers)

Referencing This Standard
Link Here

Link to Active (This link will always route to the current Active version of the standard.)

DOI: 10.1520/D1414-15